PM Series VRC Pallet Lift

Low-Cost, Stackable and Easy-to-Install

The PM Series VRC pallet lift is designed for moving materials between two or more levels. Its modular design allows for easier installation and implementation.

  • Modular Design
  • Carriage Size: Up to 6′ x 8′
  • Travel Height: Up to 36′
  • Lift Capacity: Up to 5,000 lbs
PM Series pallet lift or VRC from CIP

Benefits

  • Installs in as little as 2-3 days
  • Maximizes floor space
  • Low maintenance cost
  • Exceptional reliability
  • Simple operation and intuitive controls
  • Exceptional safety standards
  • Seamless integration into existing workflow

Features

  • Illuminated operator controls at each level
  • Simplified installation
  • Factory pre-wired
  • Data tags included
  • Quiet and efficient operation
  • Full-height carriage enclosures
  • Pit or surface mounts
  • Tested in factory for quality assurance
  • Soft Start/Soft Stop operation (VFD)

Options

  • Outside application
  • Ground level loading ramp
  • Different colors available
  • Anti-slip platform surface
  • Platform gates available

Specifications

  • Lifting Capacity: Up to 5,000 lbs
  • Carriage Size: Up to 6’W x 8’D
  • Travel Height: 8’ up to 36’
  • Speed: 19 to 21 feet per minute (standard)
  • Number of Levels: Up to 4 stops
  • Load/Unload Config: “C” or “Z” pattern
  • Power: 230V /3P, 460V/3P, or 230V/IP
  • Mounting: Surface or Pit
  • Maximum Load Height: 72’’ or 84’’
  • Loading Height: 4’’ (surface)
  • Gate Configuration: Double-swing
  • Color: Silver gray (standard)

Lift Configuration

  • “C” or loading and unloading from the same side
  • “Z” or from front to rear, or
  • Pass through, which can be opened on both sides of lift

The Lift Configuration refers to the unloading and loading pattern of the pallet lift. This lift allows for loading and unloading on the same side (“C”), from front to rear (“Z”) or pass through.

 

CIP's VRC lift configurations, C, Z, and Pass through

Engineered to exceed Safety Standards

CIP Vertical Reciprocating Conveyors (VRCs) are manufactured to meet or exceed ANSI/ASME B20.1 Safety Standards for Conveyors and Related Equipment. This is the nationally recognized standard for vertical reciprocating conveyors. Proper installation is required to meet this standard. VRCs are not subject to ANSI/ASME A17.1 elevator codes unless specified, as they are designed for material lifting only.

PM Series Pallet Lift Specs: 72″ Load Height

Dimensions are for reference use only and may vary from actual unit. DO NOT perform building modifications based on these dimensions. Accurate engineering drawings will be provided after an approved order has been placed.

PM Series VRC pallet lift diagram (72 load)

PM Series Pallet Lift Specs: 84″ Load Height

Dimensions are for reference use only and may vary from actual unit. DO NOT perform building modifications based on these dimensions. Accurate engineering drawings will be provided after an approved order has been placed.

PM Series VRC diagram (82 load)

Pin It on Pinterest

Share This